Specifying The Printer's Frame Type - Canon imagePROGRAF iPF820 User Manual

Hide thumbs Also See for imagePROGRAF iPF820:
Table of Contents

Advertisement

Specifying the Printer's Frame Type

To enable communication between the printer and computers on your network, specify the Ethernet frame
type in your NetWare environment.
Follow the steps below to specify the frame type by using imagePROGRAF Device Setup Utility or the
printer Control Panel.
Note
You can specify the frame type by using RemoteUI if the printer's IP address is congured.
Important
Before specifying the frame type, make sure the printer is on and connected to the network.
For instructions on installing imagePROGRAF Device Setup Utility, see "Installing imagePROGRAF
Device Setup Utility". (→P.416)
Specifying the Frame Type Using imagePROGRAF Device Setup
Utility
1.
Start imagePROGRAF Device Setup Utility.
2.
In the list of printers, select the printer to congure.
3.
Choose Protocol Settings from the Printer menu.
4.
In the NetWare Frame Type list, select the frame type.
5.
Click ETHERNET II under Frame Type in TCP/IP.
6.
In IP Address, enter the IP address assigned to the printer, and then enter the subnet mask in
Subnet Mask and the default gateway in Gateway Address.
Important
You must specify the IP address here to be able to congure NetWare protocol settings using
RemoteUI.
7.
Click Set.
8.
Click OK after the Conrmation message dialog box is displayed.
9.
Exit imagePROGRAF Device Setup Utility.
Network Setting (Windows)
Network Setting 461

Advertisement

Table of Contents
loading

This manual is also suitable for:

Imageprograf ipf820 proIpf820

Table of Contents