Prepare For Parts Replacement; Parts Replacement Time Has Passed; Multi-Sensor Error - Canon imagePROGRAF iPF820 User Manual

Prepare for parts replacement.

It is almost time to replace consumables for which
service is required.

Parts replacement time has passed.

It is past the recommended time to replace
consumables for which service is required.
Unknown le.
Data sent to keep the printer up to date (such as
paper information) is in the wrong format.
You have uploaded rmware for a different model.

Multi-sensor error

Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may
be impaired.
No Roll Unit.
The printer has received a print job that species Roll
2 (Lower), but the Roll Unit is not installed.
Cause
Cause
Cause
Cause
Cause
Corrective Action
You can continue to use the printer for some time
until Parts replacement time has passed. will be
displayed.
Contact your Canon dealer for assistance.
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Check the data. Turn off the printer and wait a while
before restoring power, and then resend the data.
Check the rmware version. Turn off the printer and
wait a while before restoring power, and then resend
the rmware.
If the message is displayed again, contact your
Canon dealer for assistance.
Corrective Action
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Turn off the printer and wait at least three seconds
before restoring the power.
If the message is displayed again, contact your
Canon dealer for assistance.
Corrective Action
Hold down the Stop button for a second or more to
cancel printing.
1.
Turn the printer off and install the Roll Unit.
Connect the Roll Unit Cable rmly and completely.
2.
Turn the printer on and resend the print job.
Other Messages
Error Message 675