This Paper Cannot Be Used As Size Is Not Supported; Roll Printing Is Selected; Roll Printing Is Selected, But Sheets Are Loaded; The Roll Is Empty - Canon imagePROGRAF iPF830 User Manual

iPF830

This paper cannot be used as size is not supported.

This paper cannot be used as size is not supported.
Cause
Paper that is too large for the printer has been loa-
ded.
Paper that is too small for the printer has been
loaded.
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or nozzle
checking.

Roll printing is selected.

Roll printing is selected.
Cause
You have attempted to print on a roll,
but no roll is loaded.

Roll printing is selected, but sheets are loaded.

Roll printing is selected, but sheets are loaded.
Cause
A print job for rolls was received when a
sheet is loaded.

The roll is empty.

The roll is empty.
Cause
The tailing edge of the
paper was detected
because cut sheets
were loaded in the roll
paper Paper Feed Slot.
"Lift the release lever and replace the roll."
The roll is empty.
User's Guide
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Lift the Release Lever and load unused paper A4/Letter (vertical) or larger.
More than one sheet may be required depending on the adjustment.
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,
and then print.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.
(See "Removing Sheets.")
2.
Load a new roll.
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to install the roll paper.
1.
Press the OK button and remove the paper.
2.
Load the new roll.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
3.
If no barcode was printed on the roll, specify the type of paper.
(See "Changing the Type of Paper.")
4.
If no barcode was printed on the roll, specify the paper length.
(See "Specifying the Paper Length.")
5.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
Cause
This paper cannot be used as size is not supported.
Corrective Action
P.320
➔
P.320
➔
Corrective Action
P.330
➔
P.333
➔
Corrective Action
P.357
➔
P.333
➔
Corrective Action
P.330
➔
P.333
➔
P.336
➔
P.337
➔
Corrective Action
Follow these steps to replace the used roll with a new roll of the same
type and size.
1.
Lift the Release Lever and remove the roll.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Load the new roll.
643
P.338
➔
P.340
➔