Insufficient Paper For Job; This Paper Cannot Be Used; Roll Printing Is Selected; Roll Printing Is Selected, But Sheets Are Loaded - Canon iPF670 User Manual

iPF670
Cause
Paper has been loaded
askew, or warped paper
has been loaded.

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.

This paper cannot be used.

This paper cannot be used.
Paper smaller than the printer's minimum supported
size has been loaded.
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle check-
ing.

Roll printing is selected.

Roll printing is selected.
Cause
You have attempted to print on a roll,
but no roll is loaded.

Roll printing is selected, but sheets are loaded.

Roll printing is selected, but sheets are loaded.
Cause
A print job for rolls was received when a
sheet is loaded.
User's Guide
Downloaded from ManualsPrinter.com Manuals
2.
Load the sheet, aligning it with the guide on the right.
(See "Loading Sheets in the Printer.")
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
Cause
Cause
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,
and then print.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.
(See "Removing Sheets.")
2.
Load a new roll.
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
P.340
➔
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button to stop printing.
Either change the printer driver Paper Source
setting or the GL2 Settings > Paper Source
setting in the printer menu or replace the roll
with a roll that has enough paper for the print
job, and then try printing again.
(See "Removing the Roll from the Print-
er.")
(See "Loading Rolls in the Printer.")
Press ▲ or ▼ and select Stop Printing or
press the Stop button to stop printing.
Corrective Action
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
P.310
➔
Push the Release Lever back and load unused paper of A4 size or larger.
More than one sheet may be required depending on the adjustment.
Corrective Action
P.320
➔
P.322
➔
Corrective Action
P.344
➔
P.322
➔
Insufficient paper for job
Corrective Action
P.327
➔
P.322
➔
561