Cannot Print Over A Network; Cannot Connect The Printer To The Network - Canon imagePROGRAF iPF820 User Manual

Hide thumbs Also See for imagePROGRAF iPF820:
Table of Contents

Advertisement

Cannot print over a network

Cannot print over a network

Cannot connect the printer to the network

The Ethernet cable is not connected
correctly to the printer's Ethernet port.
634 Troubleshooting
Cause
1.
Make sure the printer is connected to the network with the correct
Ethernet cable, and then turn the printer on. For instructions on
connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100
Base-TX and orange if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
Make sure the hub is on.
Make sure the end of the Ethernet cable is connected
correctly.
Insert the Ethernet cable until it clicks and locks in place.
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
Check the communication mode with the hub.
Although the printer normally detects the hub
communication mode and transmission rate automatically
(in auto negotiation mode), sometimes the hub settings
cannot be detected. In this case, congure the connection
method manually, specifying the communication mode in
use.
(→P.635)
Corrective Action

Advertisement

Table of Contents
loading

This manual is also suitable for:

Imageprograf ipf820 proIpf820

Table of Contents