HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 186

Table C-1 Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
Link Speed
176 Appendix C HP Jetdirect Control Panel Menus (V.36.xx)
Sub-menu item
Ping Results
Sub-menu item
Execute
Packets Sent
Packets Received
Percent Lost
RTT Min
RTT Max
RTT Average
Ping in Progress
Refresh
Values and Description
No (default): Results are not printed
Specify whether to initiate the ping test.
No (default): Do not run the test.
Yes: Run the test
Use this item to view the ping test status and results
using the control panel display.
Shows the number of packets (0 - 65535) sent to the
remote host since the most recent test was initiated or
completed.
Shows the number of packets (0 - 65535) received from
the remote host since the most recent test was initiated
or completed.
Shows the percent of ping test packets that were sent
with no response from the remote host since the most
recent test was initiated or completed.
Shows the minimum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
Shows the maximum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
Shows the average round-trip-time (RTT), from 0 to
4096 milliseconds, for packet transmission and
response.
Shows whether a ping test is in progress.
a test in progress, and No indicates that a test
completed or was not run.
When viewing the ping test results, this item updates
the ping test data with current results.
Yes: Update the data.
No: Maintain the existing data. However, a refresh
automatically occurs when the menu times out or you
manually return to the main menu.
The link speed and communication mode of the print
server must match the network. The available settings
depend on the device and installed print server. Select
one of the following link configuration settings:
CAUTION: If you change the link setting,
network communications with the print server
and network device might be lost.
Auto (default): The print server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A
1000T half-duplex selection is not supported.)
Yes indicates
ENWW