HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 44

Table 3-2 TFTP Configuration File Parameters (continued)
If a "trap-community-name" command is followed by "trap-dest" commands, the trap community name will be
assigned to those entries unless a different community name is specified in each "trap-dest" command.
To delete the table, use "trap-dest: 0".
If the list is empty, the print server does not send SNMP traps. The list may contain up to six entries. The default SNMP
Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a
trap daemon to listen to those traps.
IPX/SPX
ipx-config:
Enables or disables IPX/SPX protocol operation on the print server: 0 disables, 1 (default) enables.
NOTE:
ipx-unit-name:
A user-assigned alphanumeric name assigned to the print server (31 characters maximum). By default, the name will be
NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address.
ipx-frametype:
Specify the IPX frame type setting available for your print server model: AUTO (default), EN_SNAP, EN_8022, EN_8023,
EN_II.
ipx-sapinterval:
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits between Service Advertising Protocol
(SAP) broadcasts on the network. The default is 60 seconds. 0 disables SAP broadcasts.
ipx-nds-tree:
Identifies the name of the Novell Directory Services (NDS) tree for this printer.
ipx-nds-context:
An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP Jetdirect print server.
ipx-job-poll:
Specifies the time interval (seconds) that the HP Jetdirect print server will wait to check for print jobs in a print queue.
pjl-banner:
Enables or disables printing an IPX banner page. 0 disables banner pages. 1 (default) enables banner pages.
pjl-eoj:
Enables or disables IPX end-of-job notification. 0 disables, 1 (default) enables.
pjl-toner-low:
Enables or disables IPX toner-low notification. 0 disables, 1 (default) enables.
AppleTalk
appletalk:
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server: 0 disables, 1 (default) enables.
NOTE:
34 Chapter 3 TCP/IP Configuration
(or ipx/spx:)
HP Jetdirect 635n print servers: except for TCP/IP, network protocols are disabled by factory default.
(or ipx-banner:)
(or ipx-eoj:)
(or ipx-toner-low:)
(or at-config:, ethertalk:)
HP Jetdirect 635n print servers: except for TCP/IP, network protocols are disabled by factory default.
ENWW