To Disable A Jetdirect Embedded Print Server (V.36.Xx) - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

To Disable a Jetdirect Embedded Print Server (V.36.xx)

NOTE:
the printer/MFP.
You can disable an HP Jetdirect embedded print server by using the printer/MFP Service menu. This
feature can help to isolate faults to either the printer or the print server.
1. Turn the printer on and watch for the memory count to begin.
2.
Press and hold the Select
the three control panel lights (Ready, Data, Attention) blink and then remain on.
3.
Release the Select
4.
Press the down arrow
5.
Press the Select
continue its power-on sequence.
6. Verify whether the printer/MFP properly completes its power-on sequence.
To enable the embedded print server, use the same instructions except select Embedded LAN
enable in step 4 above.
120 Chapter 7 Troubleshooting the HP Jetdirect Print Server
HP Jetdirect EIO and external print servers can be disabled by disconnecting them from

button (or the "6" button on MFPs with numeric keypads only) until

button (or "6" button). The control panel will display Select.
M
button (or "9" button) until Embedded LAN disable appears.

button (or "6" button) to perform disable the embedded print server and then
ENWW