Hp Jetdirect Security Page - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 8-13 Error Messages (continued)
Error Code and Message
F1 TRYING TO CONNECT TO
SERVER
F2 TFTP IN PROGRESS
F3 BOOTP/RARP IN PROGRESS
F4 BOOTP/DHCP IN PROGRESS

HP Jetdirect Security Page

If the HP Jetdirect print server supports IPsec, an enhanced Security page can be printed from the
Jetdirect menu accessed through the printer control panel. A typical Security page is illustrated below.
To print the
1. On the printer control panel, navigate to the HP Jetdirect menus.
2. In the Jetdirect menus, locate and select the
3. In the Security, locate and select
by the print server.)
4. Select Yes. The security page will print.
146 Chapter 8 HP Jetdirect Configuration Pages
Description
●
●
The HP Jetdirect print server is trying to connect to the NetWare server(s). This is a
normal message. Wait until either the connection is established or another status
message appears.
The print server is attempting to use TFTP to obtain TCP/IP configuration settings over
the network.
The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
HP Jetdirect Security Page:
Rebind time is less than, or equal to, the Renew time.
The lease duration is less than, or equal to, the Rebind time.
Security menu item.
Print Sec Page . (This item will appear only if IPsec is supported
ENWW