HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 89

Table 4-12 Miscellaneous Settings (continued)
Item
HTTP Idle Timeout
Fax Idle Timeout
On fatal error
Error page type
Dynamic Raw Port Setting
Disable listening on these ports
Bonjour Highest Priority
Service
ENWW
Description
LPR as the source facility code, but local user values of local0 through local7 can be used
to isolate individual or groups of print servers.
Specifies the length of time after which an idle HTTP connection will be closed. The HTTP
Idle Timeout applies to the time after an HTTP request or response has completed. The
valid range is 5 to 60 seconds. The default value is 15.
If zero (0) is specified, this parameter is disabled, and the TCP/IP idle timeout value is
used.
Specifies the length of time after which an idle FAX connection will be closed. The timeout
applies to the time after a FAX request or response has completed. The valid range is 0
to 300 seconds. The default value is 300.
(Supported external print servers only) Specify the print server's action when it detects a
fatal error during operation with the attached device:
● Halt (default): The print server's networking operation is suspended. User
intervention will be required.
●
Reboot: The print server will restart, similar to when the print server is powered off/
on.
(Supported external print servers only) Specify the type of diagnostic page that will
automatically print on a fatal error.
● Basic (default): A Default Diagnostic Page will print. It is a single page containing an
error summary in user-readable form.
●
Full: Up to five pages of full diagnostic information will be printed.; These pages will
contain detailed status of the print server at the time the error was detected. HP
support personnel may be required to interpret the pages.
●
None: A diagnostic page will not be printed.
Allows additional ports to be specified for printing to TCP port 9100. Valid ports are 3000
to 9000, which are application-dependent.
NOTE: If available, this item may be superseded or overridden by the IPsec/
Firewall policy configuration, if Firewall or IPsec features are supported..
For security purposes, two fields allow you to disable services on the printer that use the
network. In each field, you must specify the port numbers that are used for network
communications with those services. Up to five ports may be specified in each field (for
example, [5, 10, 40, 20, 50]). The valid range for port numbers is 1 through 65535.
Streams: In this field, enter port numbers of services that pass data streams. Data streams
use Transport Control Protocol (TCP) to guarantee data delivery.
Datagrams: In this field, enter port numbers of services that pass datagrams. Datagrams,
typically used for broadcast messages, use the User Datagram Protocol (UDP), a
connectionless protocol where delivery and error recovery are not guaranteed.
Specifies the Bonjour highest priority service to use for printing. To set this parameter,
choose one of the following printing options:
9100 Printing: Raw IP printing through HP-proprietary port 9100.
IPP Printing: Internet Printing Protocol printing.
LPD Printing (RAW): Default LPD raw queue printing.
LPD Printing (TEXT): Default LPD text queue printing.
Networking Tab 79