Ipsec Error Log; Local Ip Addresses; Ipsec Stats - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

IPsec Error Log

This section provides IPsec error messages contained in the following table.
Table 8-15 IPsec Error Log
Message
Deprecated Template
Upgrade Jetdirect Firmware

Local IP Addresses

This section lists the IPv4 and IPv6 addresses configured on the print server.

IPsec Stats

IPsec statistics gathered and reported by the print server are described below.
Table 8-16 IPsec Statistics
Message
Fragmentation Errors
ESP MAC Errors
AH MAC Errors
Replay Errors
Drop Rule
Reject Rule
No Rule
Generic Drops
ESP (Rx/Tx):
ENWW
Description
A Service template that was created using a prior Jetdirect firmware version has been
detected. The template is in one of the following states:
●
The template is configured as a predefined template and available for use, but it
may not be valid. You should upgrade the Jetdirect firmware to the most recent
version.
● The template has been saved as a custom service template. In addition, the
template may have been replaced by a new predefined version available for your
use. Review your IPsec/Firewall policy and ensure the appropriate Service
templates are being used.
You should upgrade the firmware version on your HP Jetdirect print server.
Description
Displays the number of fragmented packets that could not be reassembled.
Displays the number of Encapsulating Security Payload (ESP) Message Authentication
Code (MAC) errors. MAC is used to verify packet integrity, that is, the message received
is the same as the one sent.
Displays the number of Authentication Header (AH) Message Authentication Code
(MAC) errors. MAC is used to verify packet integrity, that is, the message received is
the same as the one sent.
Displays the number of replay attacks, where unauthorized packets are being resent.
If the default IPsec rule is configured to drop all non-IPsec traffic, the number of dropped
packets based on the IPsec rules is displayed. Client notification of dropped packets is
not provided.
Displays the number of rejected IPsec packets. Client notification of rejected packets is
provided through ICMP error messages.
Displays the number of packets received for which an IPsec policy rule is not configured.
Displays the number of packets dropped that are not counted by other statistics.
Displays the total number of Encapsulating Security Payload (ESP) packets received
(Rx) and transmitted (Tx) by the print server.
HP Jetdirect Security Page 149