HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 181

Table C-1 Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
ENWW
Sub-menu item Sub-menu item
DHCP Renew
Manual Settings
Default IP
Primary DNS
Secondary DNS
IPv6 Settings Enable
Values and Description
No (default): The current DHCP lease is saved.
Yes: The current DHCP lease and the leased IP
address are released.
This menu appears if
DHCP and a DHCP lease for the print server exists.
No (default): The print server does not request to renew
the DHCP lease.
Yes: The print server requests to renew the current
DHCP lease.
(Available only if Config Method
Configure parameters directly from the printer control
panel:
IP Address: The unique IP address of the printer, where
n is a value from 0 to 255.
Subnet Mask: The subnet mask for the printer, where
m is a value from 0 to 255.
Syslog Server: The IP address of the syslog server
used to receive and log syslog messages.
Default Gateway: The IP address of the gateway or
router used for communications with other networks.
Idle Timeout: The time period, in seconds, after which
an idle TCP print data connection is closed (default is
270 seconds, 0 disables the timeout).
Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
Auto IP: A link-local IP address 169.254.x.x is set.
Legacy: The address 192.0.0.192 is set, consistent
with older HP Jetdirect devices.
Specify the IP address (n.n.n.n) of a Primary DNS
Server.
NOTE: This item appears only if
configuration is a higher priority than
the Config Precedence table, configured
through the embedded Web server.
Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
NOTE: This item will appear only if
configuration is a higher priority than
the Config Precedence table, configured
through the embedded Web server.
Use this item to enable or disable IPv6 operation on the
print server.
Jetdirect Menus for Graphical Control Panels 171
Config Method was set to
is set to Manual)
Manual
DHCP
Manual
DHCP
in
in