HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 66

Table 3-3 Telnet Commands and Parameters (continued)
usb-mode
usb-speed
status-page-lang
job-timeout
Support
56 Chapter 3 TCP/IP Configuration
CAUTION: If you change the link setting, network communications with the print
server and network device may be lost.
AUTO (default): The print server uses auto-negotiation to configure itself with the highest
link speed and communication mode allowed.
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
100HALF: 100 Mbps, half-duplex operation.
10FULL: 10 Mbps, Full-duplex operation.
10HALF: 10 Mbps, half-duplex operation.
Specifies the communication mode over the USB port on the HP Jetdirect print server.
●
Auto (default): Automatically negotiates and sets the highest communication mode
possible for the attached printer or device.
●
MLC: (Multiple Logical Channels) An HP-proprietary communication mode that allows
multiple channels of simultaneous print, scan and status communications.
● BIDIR: A standard connection that supports bi-directional communications between
the printer and print server. The print server sends print data and receives status from
the printer.
● UNIDIR: A standard connection in which data is transferred in one direction only (to
the printer).
(Read-only parameter, USB 2.0 products only) Specifies the autonegotiated
communication speed over the USB connection between the HP Jetdirect print server and
the device.
●
Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible
with USB v1.1 specifications.
●
Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
● Disconnected: The USB port is not connected.
Specifies the printer job language (PJL) that the print server will use to send the Jetdirect
configuration/status page to the printer.
●
Auto (default): The PDL is auto-detected when the print server is powered on or after
a cold-reset.
●
PCL: Hewlett-Packard Printer Control Language
● ASCII: Standard ASCII characters
●
HPGL2: Hewlett-Packard Graphics Language (v2)
● PS: Postscript language
(External print servers only) Specifies the time period after which an idle connection to the
printer (for example, through the USB port) will be closed.
An integer from 30 to 4294967295 seconds may be specified. If 0 is specified, the default
value of 270 seconds is used.
ENWW