HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 155

Table 8-13 Error Messages (continued)
Error Code and Message
53 BAD BOOTP TAG SIZE
54 BOOTP/RARP IN PROGRESS
55 BOOTP/DHCP IN PROGRESS
56 DHCP NAK
57 UNABLE TO CONNECT DHCP
SVR
58 POSTSCRIPT MODE NOT
SELECTED
59 INCOMPLETE F/W - MUST
DOWNLOAD
5A TURN PRINTER OFF / ON
5C DHCP BAD REPLY
5D DHCP LEASE DURATION TOO
SHORT
5E DHCP LEASE RELEASED
5F WINS REGISTRATION FAILED
61 AUTO IP CONFIGURED
62 DEFAULT IP CONFIGURED
63 AUTO IP IN PROGRESS
64 INVALID PASSWORD
83 DISCONNECTING FROM
SERVER
84 DHCP LEASE TIMERS
ADJUSTED
ENWW
Description
BOOTPREPLY(0X02), had a header field that did not match the print servers hardware
address, or had a UDP source port that was not the BOOTP/DHCP server port (67/udp).
The tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than
the remaining number of unprocessed bytes in the vendor-specified area.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected any errors.
The HP Jetdirect print server received a negative acknowledgement message from the
DHCP server in response to a configuration request.
The HP Jetdirect print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the IP address of the most
recent DHCP server used, but operation may be degraded until a DHCP server
responds.
The printer does not support AppleTalk or AppleTalk extensions.
Firmware download message. Currently downloading firmware to the HP Jetdirect print
server, or the download did not complete properly.
Firmware download message. Download of firmware is complete. Power off/on the HP
Jetdirect print server.
A bad reply was received from the DHCP server. Check your DHCP server settings for
this print server.
The DHCP lease times for this print server's TCP/IP configuration settings are too short.
Re-configure the DHCP lease times on the DHCP server.
The lease for DHCP-configured parameters, including the IP address, have been
released through a manual configuration method, such as through the printer's control
panel.
Attempts to register the print server's name on the WINS server failed. Check for
duplicate names, or verify the WINS server configuration.
An IP address could not be retrieved over the network. The print server will default to
an IP address using link-local addressing in the form 169.254.x.x.
An IP address could not be retrieved over the network. The print server will default to a
legacy default IP address 192.0.0.192.
The print server is automatically assigning an IP address using link-local addressing in
the form 169.254.x.x.
An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
The server has been shut down because of a configuration change or reset request.
This message automatically clears after a few seconds, unless the printer is offline, is
in an error state, or is servicing another I/O port or another network protocol.
The print server detected a DHCP lease error due to one of the following conditions:
●
Renew time is less than 30 seconds.
● Rebind time is less than 52 seconds.
HP Jetdirect Configuration Page 145