HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 59

Table 3-3 Telnet Commands and Parameters (continued)
bonjour-svc-name
Bonjour Domain Name
bonjour-pri-svc
ftp-download
ttl-slp
ipv4-multicast
idle-timeout
ENWW
Specifies an alphanumeric string of up to 64 ASCII characters assigned to this device or
service. This name is persistent and is used to resolve a particular device or service if
socket information (such as the IP address) changes from session to session. Apple
Bonjour will display this service. The default service name is the printer model and the LAN
Hardware (MAC) address.
(Read-only parameter) Specifies the Bonjour domain name assigned to the device, in the
form <host name>.local. If a user-specified host name has not been assigned, the default
host name NPIxxxxxx is used, where xxxxxx are the last 6 digits of the LAN hardware
(MAC) address.
Specifies the Bonjour highest priority service to use for printing. To set this parameter,
choose one of the following printing option numbers:
1: Port 9100 printing
2: IPP port printing
3: The default LPD raw queue
4: The default LPD text queue
5: The default LPD auto queue
6: The default LPD binps (binary PostScript) queue
7 through 12: If user-specified LPD queues are defined, corresponds to user-specified
LPD queues 5 through 10.
The default selection will depend on the printer, typically port 9100 printing or LPD binps.
Enable or disable the ability to download firmware upgrade files to the print server using
FTP (File Transfer Protocol).
0 disables.
1 (default) enables.
Specifies the IP multicast "Time To Live" (TTL) setting for Service Location Protocol (SLP)
packets. The default value is 4 hops (the number of routers from the local network). The
range is 1–15. When set to –1, multicast capability is disabled.
Enables or disables the receipt and transmission of IP version 4 multicast packets by the
print server.
0 disables.
1 (default) enables.
NOTE: If this parameter is disabled, other protocols that use multicast protocols,
such as Bonjour and SLP, may also be disabled without notification.
An integer (1to 3600) that specifies the number of seconds an idle print data connection
is allowed to remain open. For example,
idle-timeout 120
assigns 120 seconds as the desired idle timeout value.
The default is 270 seconds. If set to 0, the connection will not terminate and other hosts
will not be able to make a connection.
IPv4 Configuration 49