HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 183

Table C-1 Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
IPX/SPX
AppleTalk
DLC/LLC
Security
ENWW
Sub-menu item Sub-menu item
Proxy Server
Proxy Port
Enable
Frame Type
Enable
Enable
Print Sec Page
Secure Web
Values and Description
Specifies the proxy server to be used by embedded
applications in the device. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet security,
for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy
server address.
Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can be
a value from 0 to 65535.
Off: Disable the IPX/SPX protocol.
On: Enable the IPX/SPX protocol.
NOTE: The factory default setting depends
on the print server model.
Selects the frame-type setting for your network.
Auto: Automatically sets and limits the frame type to
the first one detected.
EN_8023, EN_II, EN_8022, and EN_SNAP: Frame-
type selections for Ethernet networks
Off: Disable the AppleTalk protocol.
On: Enable the AppleTalk protocol.
NOTE: The factory default setting depends
on the print server model.
Off: Disable the DLC/LLC protocol.
On: Enable the DLC/LLC protocol.
NOTE: The factory default setting depends
on the print server model.
NOTE: This item will appear only if IPsec is
supported by the print server.
Yes: Prints a page that contains the current IPsec
security settings on the HP Jetdirect print server.
No (default): A security settings page is not printed.
For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP and
HTTPS.
Jetdirect Menus for Graphical Control Panels 173