HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 60

Table 3-3 Telnet Commands and Parameters (continued)
user-timeout
cold-reset
ews-config
web-refresh
tcp-mss
tcp-msl
gw-disable
default-ip
default-ip-dhcp
50 Chapter 3 TCP/IP Configuration
An integer (1to 3600) that specifies the number of seconds that your Telnet or FTP session
can be idle before it will be automatically disconnected. The default is 900 seconds. 0
disables the timeout.
CAUTION: Small values, such as 1–5, may effectively disable the use of Telnet.
A Telnet session may terminate before any changes can be made.
1: Sets TCP/IP factory default settings. After a cold reset, power cycle the print server.
Parameters for other subsystems, such as IPX/SPX or AppleTalk, are not affected.
0: Normal operation, and reset is disabled.
Enables or disables the print server's embedded Web server.
0 disables.
1 (default) enables.
For more information, see Embedded Web Server (V.36.xx) on page
Specifies the time interval (1–99999 seconds) for embedded Web server diagnostic page
updates. If set to 0, the refresh rate is disabled.
Specifies the maximum segment size (MSS) that the HP Jetdirect print server will advertise
for use when communicating with local subnets (Ethernet MSS=1460 bytes or more) or
remote subnets (MSS=536 bytes):
0: (default) All networks are assumed to be local (Ethernet MSS=1460 bytes or more).
1: Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote networks.
2: All networks are assumed to be remote (MSS=536 bytes), except the local subnet.
MSS affects performance by helping to prevent IP Fragmentation that may result in data
retransmission.
Specifies the maximum segment life (MSL) in seconds. The range is 5–120 seconds. The
default is 15 seconds.
Specifies whether or not to automatically assign the device IP address as the gateway
when a network gateway is not configured.
0: A gateway using the device IP address will be assigned.
1: A gateway is not assigned. The gateway address 0.0.0.0 will be configured.
Specifies the IP address to use when the print server is unable to obtain an IP address
from the network during a forced TCP/IP reconfiguration (for example, when powered off/
on or manually configured to use BOOTP/DHCP).
DEFAULT_IP: sets the legacy default IP address 192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained when first powered on.
Specifies whether DHCP requests will be periodically transmitted when a legacy default
IP address 192.0.0.192 or link-local IP address 169.254.x.x has been automatically
assigned.
0: Disables DHCP requests.
1 (default): Enables DHCP requests.
61.
ENWW