Other Settings; Misc. Settings - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 4-11 SNMP Tab Settings (continued)
Item

Other Settings

This item provides access to a variety of management and printing configuration options. The following
tabs are provided:
●
Misc. Settings on page
●
Firmware Upgrade on page
enhancements
●
LPD Queues on page
daemon) printing services
●
USB Settings on page
connection parameters
●
Support Info on page
●
Refresh Rate on page
page updates

Misc. Settings

The Misc. Settings (Miscellaneous Settings) parameters allow you to set a variety of advanced
protocols and features, as described below. See
Table 4-12 Miscellaneous Settings
Item
SLP Config
Telnet Config
Bonjour
Multicast IPv4
ENWW
Description
Authentication Key: a 16-byte hexadecimal value for authenticating the SNMP packet
contents using the Message Digest Algorithm 5 (MD5, RFC 1321).
Privacy Key: a 16-byte hexadecimal value for encrypting the data portion of the SNMP packet
using the Data Encryption Standard (DES) algorithm.
Context Name: the view context in which this user can access SNMP objects. It is always
"Jetdirect".
77: for enabling miscellaneous advanced protocols and functions
80: to update your HP Jetdirect print server with new features and
80: for setting up print queues used in printing under LPD (line printer
82: (external print servers only) to configure Universal Serial Bus
83: to set up the Support link located under Other Links in the left margin
83: to set the time interval (in seconds) for embedded Web diagnostic
Description
Enable or disable SLP (Service Location Protocol), used by selected client application
software to automatically discover and identify the HP Jetdirect print server.
If SLP will use multicast protocols, Multicast IPv4 must be enabled.
Enable or disable access to HP Jetdirect configuration parameters using Telnet. For more
information, see TCP/IP Configuration on page
Enable or disable Bonjour services (formerly listed as Multicast Domain Name System, or
mDNS, services). Bonjour is typically used for IP address and name resolution (through
UDP port 5353) where a conventional DNS server is not used.
For Bonjour operation, Multicast IPv4 must be enabled.
Enable or disable the receipt and transmission of IP version 4 multicast packets by the
print server. If this parameter is disabled, other protocols that use multicast protocols, such
as Bonjour and SLP, may also be disabled without notification.
Table 4-12 Miscellaneous Settings on page
17.
77.
Networking Tab 77