HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 182

Table C-1 Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
172 Appendix C HP Jetdirect Control Panel Menus (V.36.xx)
Sub-menu item Sub-menu item
Address
DHCPv6 Policy
Primary DNS
Secondary DNS
Values and Description
Off: IPv6 is disabled.
On (default): IPv6 is enabled.
Use this item to manually configure an IPv6 address.
Manual Settings: Use the Manual Settings
enable and manually configure a TCP/ IPv6 address.
Enable: Select this item and choose
manual configuration, or Off
configuration.
Address: Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Router Specified: The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
Router Unavailable: If a router is not available, the print
server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
NOTE: This item will appear only if
configuration is a higher priority than
the Config Precedence table, configured
through the embedded Web server.
Use this item to specify an IPv6 address for a
secondary DNS server that the print server should use.
NOTE: This item will appear only if
configuration is a higher priority than
the Config Precedence table, configured
through the embedded Web server.
menu to
On to enable
to disable manual
Manual
DHCP in
Manual
DHCP in
ENWW