Default Ip Address (Ipv4); Default Ip Address Will Not Be Assigned; Default Ip Address Will Be Assigned - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Jetdirect print servers
Hide thumbs Also See for 635n - JetDirect IPv6/IPsec Print Server:
Table of Contents

Advertisement

two minutes may be used for these methods. If configuration is not successful, a default IP address will
be assigned.
The print server may also be configured manually. Manual-based tools include Telnet, a Web browser,
the printer control panel, arp and ping commands (when the default IP address is 192.0.0.192), or
SNMP-based management software. TCP/IP configuration values assigned manually will be retained
when powered off/on.
The print server can be reconfigured to use either server-based or manual configuration of TCP/IP
settings at any time.
To identify the IP address that is configured on the print server at any time, see the HP Jetdirect
configuration page.

Default IP Address (IPv4)

When in a factory-default state (for example, when shipped from the factory or after a cold-reset), the
HP Jetdirect print server has no IP address. A default IP address may or may not be assigned depending
on the network environment.

Default IP Address Will Not Be Assigned

A default IP address will not be assigned if a server-based method (such as BOOTP or DHCP) is
successful. And if the print server is powered off/on, the same method will again be used to retrieve IP
configuration settings. If this method now fails to retrieve the IP configuration settings (for example, the
BOOTP or DHCP server is no longer available), a default IP address will not be assigned. Instead, the
print server will continue to send IP configuration requests indefinitely. You must cold-reset the print
server to change this behavior.
In addition, a default IP address will not be assigned if a network cable is not attached to a wired print
server.

Default IP Address Will Be Assigned

A default IP address will be assigned if the factory-default methods fail, or if the print server has just
been reconfigured by an administrator to use a server-based method (such as BOOTP or DHCP) that
fails.
ENWW
IPv4 Configuration
21

Advertisement

Table of Contents
loading

Table of Contents