HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 62

Table 3-3 Telnet Commands and Parameters (continued)
DHCP Renew Time
DHCP Rebind Time
SNMP
snmp-config
get-cmnty-name
set-cmnty-name
default-get-cmnty
SNMP Traps
auth-trap
trap-dest
52 Chapter 3 TCP/IP Configuration
(Read-only parameter) DHCP T1 timeout, specifying the DHCP lease renewal time
(seconds).
(Read-only parameter) DHCP T2 timeout, specifying the DHCP lease rebind time
(seconds).
Enables or disables SNMP operation on the print server.
CAUTION: Disabling SNMP will disable all SNMP agents (SNMP v1, v2, v3) as
well as communications with management applications, such as HP Web
Jetadmin. In addition, firmware upgrades through current HP downloading utilities
will be disabled.
0 disables,
1 (default) enables SNMP.
Specifies a password that determines which SNMP GetRequests the HP Jetdirect print
server will respond to. This is optional. If a user-specified get community name is set, the
print server will respond to either a user-specified community name or the factory-default.
The community name must be ASCII characters. The maximum length is 255 characters.
Specifies a password that determines which SNMP SetRequests (control functions) the
HP Jetdirect print server will respond to. The community name of an incoming SNMP
SetRequest must match the print server's "set community name" for the print server to
respond. (For additional security, you may limit configuration access through the print
server's host access list.) Community names must be ASCII characters. The maximum
length is 255 characters.
Enables or disables the default Get community name.
0 disables.
1 (default) enables.
Disabling this parameter may prohibit communications with SNMP management
applications.
Configures the print server to send (on) or not send (off) SNMP authentication traps.
Authentication traps indicate that an SNMP request was received, but the community name
check failed. .
0 is off.
1 (default) is on
Enters a host IP address into the HP Jetdirect print server's SNMP trap destination list.
The command format is:
trap-dest: <ip-address> [community name] [port number]
Where <ip-address> is the IP address of the host to receive traps, [community
name] specifies the SNMP community name, and [port number] identifies the port
number to use.
The default community name is 'public'; the default SNMP port number is '162'. The port
number cannot be specified without a community name.
To delete the list, use trap-dest: 0.
ENWW