HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 154

Table 8-13 Error Messages (continued)
Error Code and Message
3F UNABLE TO GET NDS SRVR
ADDR
40 ARP DUPLICATE IP ADDRESS
41 NOVRAM ERROR
42 INVALID IP ADDRESS
43 INVALID SUBNET MASK
44 INVALID GATEWAY ADDRESS
45 INVALID SYSLOG ADDRESS
46 INVALID SERVER ADDRESS
47 INVALID TRAP DEST ADDRESS
48 CF ERR - FILE INCOMPLETE
49 CF ERR - LINE TOO LONG
4A CF ERR - UNKNOWN
KEYWORD
4B CF ERR - MISSING
PARAMETER
4C CF ERR - INVALID PARAMETER
4D CF ERR - ACCESS LIST
EXCEEDED
4E CF ERR - TRAP LIST
EXCEEDED
4F TFTP REMOTE ERROR
50 TFTP LOCAL ERROR
51 TFTP RETRIES EXCEEDED
52 BAD BOOTP/DHCP REPLY
144 Chapter 8 HP Jetdirect Configuration Pages
Description
The NDS server address cannot be located or accessed.
The ARP layer has detected another node on the network using the same IP address
as the HP Jetdirect print server. Extended error information below this message shows
the hardware address of the other node.
The HP Jetdirect print server cannot read the contents of its NOVRAM.
The IP address specified for the HP Jetdirect print server (through BOOTP) is an invalid
IP address for specifying a single node. Check your Bootptab file for proper entries.
The IP subnet mask specified for the HP Jetdirect print server (through BOOTP) is an
invalid subnet mask. Check your Bootptab file for proper entries.
The default gateway IP address specified for the HP Jetdirect print server (through
BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file
for proper entries.
The syslog server IP address specified for the HP Jetdirect print server (through
BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab file
for proper entries.
The TFTP server IP address specified for the HP Jetdirect print server (through BOOTP)
is an invalid IP address for specifying a single node. Check your Bootptab file for proper
entries.
One of the SNMP trap (Trap PDU) destination IP addresses specified for the HP
Jetdirect print server (through TFTP) is an invalid IP address for specifying a single
node. Check your TFTP configuration file.
The TFTP configuration file contained an incomplete last line that did not end in a
newline character.
A line being processed in the TFTP configuration file was longer than the HP Jetdirect
print server could accept.
A TFTP configuration file line contained an unknown keyword.
A line in the TFTP configuration file was missing a required parameter.
A line in the TFTP configuration file contained an invalid value for one of the parameters
on that line.
The TFTP configuration file specified too many access list entries using the "allow:"
keyword.
The TFTP configuration file specified too many trap destination list entries using the
"trap-destination:" keyword.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the remote host sending a TFTP error packet to the print server.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the local print server encountering some form of inactivity timeout, or
excessive retransmissions situation.
The overall retrying of the TFTP transfer of the configuration file from the host to the HP
Jetdirect print server has exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server
received. The reply either had insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not
ENWW