Step 3: Specify Action - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 5-6 Manage Custom Services page (continued)
Item
Service Type
Service Port
ICMP Message Type
Add
Configured Custom Services
Delete

Step 3: Specify Action

For the addresses and services specified for this rule, select an action for the print server. Selectable
actions on this page depend on whether IPsec is supported.
●
Allow traffic. (If IPsec is supported, allow traffic to pass without IPsec protection.)
●
Drop traffic. Do not process (discard) the specified IP traffic.
●
Require traffic to be protected with an IPsec/Firewall policy. This option appears if IPsec/Firewall
features are supported. If IPsec is supported, you will be prompted to select or configure an IPsec
template to be applied to the specified IP traffic.
ENWW
Description
(Internet Control Message Protocol for IPv4/IPv6 networks), and IGMPv2 (Internet
Group Management Protocol version 2).
●
For TCP or UDP, you must specify the local Printer/MFP ports and remote host
ports for the service.
●
For ICMPv4 or ICMPv6, you must specify an ICMP message type for the service.
ICMP message types are based on standards and are well known.
●
For IGMPv2, local/remote ports or ICMP message types are not configured; all
IGMP messages types are assumed.
Specify the service type:
●
Printer/MFP Service (default): A local service on the HP Jetdirect print server or
device.
●
Remote Service: A service on a remote host.
If the protocol selected was TCP or UDP, select the ports for this custom service to use
on the local printer/MFP, and the remote hosts. The default selection is Any Port.
Depending on the service, select Port Range or Specific Port, then enter the port range
or port in the fields provided.
If the protocol selected was ICMPv4 or ICMPv6, enter the ICMP message type number
that will be used by the service. ICMP (Internet Control Message Protocol) does not use
ports; instead, it uses well-known message types.
NOTE: ICMP messages are typically used for error, control or information
messages between network hosts.
Use this button to add the custom service to the Configured Custom Services list.
This list identifies the custom services that have been configured.
Use this button to delete a configured custom service from the list. Select the service
to be deleted and click Delete. However, to delete a custom service, it cannot be
specified for use by an active service template.
HP Jetdirect IPsec/Firewall Wizard 105