Select Language; Security: Settings; Status; Wizard - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

information assists HP in improving product features and services. The default setting for this page will
depend on the user's selection on initial access to the Networking tab.
To enable this feature, check the checkbox and click Apply.
To disable this feature, clear the checkbox and click Apply.

Select Language

This link appears if the HP Jetdirect Web pages support multiple languages. Supported languages may
also be selected through language preference settings in your browser (see your browser's Help).
To display supported non-English languages, the use of cookies must be enabled in your browser
settings.

Security: Settings

In the SECURITY section, the Settings menu provides access to the following tabs: Status (default),
Wizard, Restore Defaults. The available settings depend on your particular print server model.

Status

The Status page displays the current security configuration settings of the print server. The settings
that will be displayed depend on the features supported by the print server.

Wizard

NOTE:
Instead, use HP Web Jetadmin to configure your network security settings to ensure they are
properly set for your network.
Select the Wizard tab to open the initial Wizard page. If prompted with security alerts, click Yes to
proceed.
The Wizard page identifies the current security level that was last configured on the print server. If a
security level has not been configured, the security level will be None. However, if HTTPS is required
for access to the networking pages, then the default setting will indicate Custom.
In addition, this page allows you to run the HP Jetdirect Security Configuration Wizard to configure or
change the current security level. This wizard will guide you through the print server's security
configuration settings for your network. Click Start Wizard to run the wizard. This opens the Security
Level page.
The optional configuration parameters presented by the wizard will depend on your choice of security
level. For an overview, see
NOTE:
Operation Failed screen may appear. If so, wait approximately two minutes before entering the
wizard again.
Table 4-15 Wizard Security Levels
Security Level
Basic Security
84 Chapter 4 Embedded Web Server (V.36.xx)
If you use HP Web Jetadmin to manage your devices, you should not use this wizard.
Table 4-15 Wizard Security Levels on page
If you improperly exit the wizard (for example, by failing to use the Cancel button), an
Description
This option requires that you configure an administrator password for configuration
management. The administrator password is shared with other management tools, such
84.
ENWW