HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 63

Table 3-3 Telnet Commands and Parameters (continued)
IPX/SPX
ipx-config
ipx-unitname
Address
ipx-frametype
ipx-sapinterval
ipx-mode
ipx-nds-tree
ipx-nds-context
ipx-job-poll
pjl-banner
(ipx-banner)
pjl-eoj
(ipx-eoj)
pjl-toner-low
(ipx-toner-low)
AppleTalk
ENWW
If the list is empty, the print server does not send SNMP traps. The list may contain up to
six entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the
systems listed on the SNMP trap destination list must have a trap daemon to listen to those
traps.
Enables or disables IPX/SPX protocol operation on the print server, if supported.
0 disables.
1 (default) enables.
For example,
ipx-config 0 will disable IPX/SPX operation.
NOTE: HP Jetdirect 635n print servers: except for TCP/IP, network protocols
are disabled by factory default.
(Print Server Name) A user-assigned alphanumeric name assigned to the print server (31
characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last
six digits of the LAN hardware address.
(Read-only parameter) Identifies the IPX network and node numbers detected on the
network, in the form <network number>:<LAN hardware address>.
Specifies the IPX frame type settings available for your print server model: AUTO (default),
EN_SNAP, EN_8022, EN_8023, EN_II. For more information, see
Configuration Pages on page
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits
between Service Advertising Protocol (SAP) broadcasts on the network. The default is 60
seconds. 0 disables SAP broadcasts.
(Read-only parameter) Specifies the NetWare mode configured on the print server, either
RPRINTER or QSERVER mode.
An alphanumeric string, up to 31 characters, that specifies the NDS tree name for the print
server.
An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP
Jetdirect print server.
Specifies the time interval (1 to 255 seconds) that the HP Jetdirect print server will wait to
check for print jobs in a print queue. The default is 2 seconds.
Enables or disables printing an IPX banner page through Printer Job Language (PJL).
0 disables banner pages.
1 (default) enables banner pages.
Enables or disables IPX end-of-job notification through PJL.
0 disables.
1 (default) enables.
Enables or disables IPX toner-low notification through PJL.
0 disables.
1 (default) enables.
127.
HP Jetdirect
IPv4 Configuration 53