Dlc/Llc; Snmp - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

DLC/LLC

Using the checkbox provided, you can enable (check) or disable (clear) the DLC/LLC (Data Link Control/
Logical Link Control) protocols on the HP Jetdirect print server. If the checkbox is clear, DLC/LLC
protocols are disabled.
NOTE:
factory default.

SNMP

You can specify or change the SNMP (Simple Network Management Protocol) parameters provided.
See Table 4-11 SNMP Tab Settings on page
CAUTION:
Jetadmin to seamlessly configure SNMP v3 and other security settings on the print server.
Using the embedded Web server to create the SNMP v3 account will erase any existing SNMP
v3 accounts. In addition, the SNMP v3 account information will need to be implemented on the
SNMP management application. For more information, see
Table 4-11 SNMP Tab Settings
Item
Enable SNMPv1/v2 read-
write access
Enable SNMPv1/v2 read-
only access
Disable SNMPv1/v2
Enable SNMPv3
76 Chapter 4 Embedded Web Server (V.36.xx)
HP Jetdirect 635n print servers: except for TCP/IP, network protocols are disabled by
If you use HP Web Jetadmin to manage your devices, you should use HP Web
Description
This option enables the SNMP v1/v2c agents on the print server. Custom community names
can be configured to control management access to the print server.
An SNMP Set Community Name is a password to be able to configure (or "write") SNMP
information on the HP Jetdirect print server.
An SNMP Get Community Name is a password to retrieve (or "read") SNMP information on the
HP Jetdirect print server.
An incoming SNMP SetRequest or GetRequest command must contain the appropriate Set or
Get community name before the print server will respond.
A community name must be ASCII characters and can be up to 255 characters long.
To restrict access, the default Get community name "public" can be disabled by checking the
checkbox provided.
NOTE:
operate properly.
This option enables the SNMP v1/v2c agents on the print server, but limits access to read-only.
Write-access is disabled. The default Get community name "public" is automatically enabled.
This option disables the SNMP v1/v2c agents on the print server, which is recommended for
secure environments. If SNMP v1/v2c is disabled, some port monitors or discovery utilities may
not operate properly.
(Full-featured HP Jetdirect print servers only) This option enables (check) or disables (clear)
the SNMP v3 agent on the print server.
When enabled, an SNMP v3 account must be created on the print server, and the account
information must be implemented on the SNMP v3 management application. You may create
an account by providing the following information:
User Name: the SNMP v3 account user name.
76.
If "public" is disabled, some port monitors or discovery utilities may not
SNMP v3 on page 92.
ENWW