Table of Contents
Advertisement
Media Flow Controller and Media Flow Manager Installation GuideCHAPTER 3 Installing Media Flow Controller with a
Reset Ethernet Device Naming Back to Default, Ethernet Naming Option 6
If at any time in the Ethernet naming process, you want to revert back to the default names
assigned by the system, you can use option 6.
Example after assigning interfaces names using option 4 or 5 (input shown in bold):
Done specifying the device to eth number mapping.
The new mapping is:
0000:04:00.0,00:13:72:3C:33:56 eth0
0000:05:00.0,00:13:72:3C:33:57 eth1
0000:01:00.0,00:15:17:8A:49:90 eth10
0000:01:00.1,00:15:17:8A:49:91 eth11
Use this mapping? (y/n) y
Saving...
Enter 1 to Reboot to complete the installation.
Enter 2 to Halt. Installation will continue when rebooted.
Enter 3 to Flash ethernet port LEDs.
Enter 4 to Configure ethernet device names interactively.
Enter 5 to Specify devices to use for eth0 and eth1.
Enter 6 to Reset ethernet device naming back to default.
Enter 1, 2, 3, 4, 5 or 6 : 6
Done
Enter 1 to Reboot to complete the installation.
Enter 2 to Halt. Installation will continue when rebooted.
Enter 3 to Flash ethernet port LEDs.
Enter 4 to Configure ethernet device names interactively.
Enter 5 to Specify devices to use for eth0 and eth1.
Enter 6 to Reset ethernet device naming back to default.
Enter 1, 2, 3, 4, 5 or 6 :
Installing Media Flow Controller Software—CD or USB
When the Media Flow Controller software is installed on a machine that does not currently
have Media Flow Controller installed, it completely formats all disks in the system. While the
software is installing, no progress indicator is given while formatting the drives. Please be
patient. When installing on a machine that has Media Flow Controller currently installed, you
have a choice to retain the data in the caches.
To install Media Flow Controller with a CD or USB:
1. If your computer shares the CD boot drive or USB boot port with other computers then the
CD or USB drive might not be immediately available. If this happens this installation menu
is displayed:
Enter 1 to Reboot without installing or restoring
Enter 2 to Halt without installing or restoring
Enter 3 to Attempt to install from Installation Media
2. Enter 3. A welcome message is displayed followed by a prompt for the end-user license
agreement (EULA):
Enter 1 to Read the EULA agreement and continue with installation.
Enter 2 to Reboot without installing or restoring.
Installing Media Flow Controller Software—CD or USB
31
Advertisement
Table of Contents
