Cablestatus; Auto-Negotiate; Auto-Negotiate All - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.1.2 cablestatus

This command tests the status of the cable attached to an interface.
Format
Mode

4.1.3 auto-negotiate

This command enables automatic negotiation on a port.
Default
Format
Mode
4.1.3.1 no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is disabled.
Format
Mode

4.1.4 auto-negotiate all

This command enables automatic negotiation on all ports. The default value is enable.
Format
Mode
4.1.4.1 no auto-negotiate all
This command disables automatic negotiation on all ports.
Format
Mode
4-2
cablestatus <slot/port>
Privileged EXEC
enabled
auto-negotiate
Interface Config
no auto-negotiate
Interface Config
auto-negotiate all
Global Config
no auto-negotiate all
Global Config
v1.0, March 2006
Port and System Setup Commands