Snmptrap Ipaddr; Snmptrap Mode; Snmp Trap Link-Status - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

10.1.16 snmptrap ipaddr

This command assigns an IP address to a specified community name. The maximum
length of name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make
Format
Mode

10.1.17 snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
Mode
10.1.17.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive.
Format
Mode

10.1.18 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10-8
multiple entries using the same IP address, the first entry is retained and
processed. All duplicate entries are ignored.
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Global Config
snmptrap mode <name> <ipaddr>
Global Config
no snmptrap mode <name> <ipaddr>
Global Config
'snmp-server enable traps linkmode' command.
snmp trap link-status
Interface Config
v1.0, March 2006
SNMP Commands