Adding And Removing Interfaces From A Link Bundle - Cisco ASR 920 Series Configuration Manual Ethernet Router

Adding and Removing Interfaces from a Link Bundle

Examples
Device> enable
Device# configure terminal
Device(config)# lacp system-priority 200
Device(config)# interface gigabitethernet 0/1/1
Device(config-if)# lacp port-priority 500
Device(config-if)# end
This example shows how to verify the LACP configuration:
Device# show lacp sys-id
200.abdc.abcd.abcd
Adding and Removing Interfaces from a Link Bundle
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type slot/subslot/port
4. channel-group channel-group-number mode {active | passive}
5. no channel-group channel-group-number
6. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 interface type slot/subslot/port
Example:
Device(config)# interface gigabitethernet 0/0/5
Step 4 channel-group channel-group-number mode {active
| passive}
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
366
Configuring IEEE 802.3ad Link Bundling
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures a Gigabit Ethernet interface.
Adds an interface to a channel group and enters interface
configuration mode.