Verify Mpls L3Vpn Configuration Over Segment Routing - Cisco NCS 540 Series Configuration Manual

MPLS L3VPN Overview
mpls traffic-eng router-id Loopback0
segment-routing mpls
!
interface Loopback0
address-family ipv4 unicast
prefix-sid index 30103
!
Related Topics
You must perform these tasks as well to complete the MPLS L3VPN configuration over segment routing:
•
•

Verify MPLS L3VPN Configuration over Segment Routing

• Verify the statistics in core router and ensure that the counter for IGP transport label (64003 in this
• Verify the statistics in PE1 router:
• Verify the statistics in PE2 router and ensure that the counter for the VPN label (24031 in this example)
Also, refer
outputs.
Connect MPLS VPN Customers, on page 15
Configure Multiprotocol BGP on the PE Routers and Route Reflectors, on page 12
example) is increasing:
P node:
Router-P#show mpls forwarding
Local Outgoing Prefix
Label Label or ID
------ ----------- ------------------ ------------ --------------- ---------
64003 Pop SR Pfx (idx 0)
PE1:
Router-P#show mpls forwarding
Local Outgoing Prefix
Label Label or ID
------ ----------- ------------------ ------------ ------------
64001 60003 SR Pfx (idx 0)
is increasing:
PE2:
Router-PE2#show mpls forwarding
Local Outgoing Prefix
Label Label or ID
------ ----------- ------------------ ------------ --------------- ---------
24031 Aggregate vrf1601: Per-VRF Aggr[V]
Verify MPLS L3VPN Configuration, on page 25
L3VPN Configuration Guide for Cisco NCS 540 Series Routers, IOS XR Release 6.3.x
Verify MPLS L3VPN Configuration over Segment Routing
Outgoing Next Hop
Interface
Hu0/0/1/0 193.16.1.2
Outgoing Next Hop
Interface
Hu0/0/1/1 191.22.1.2
Outgoing Next Hop
Interface
\
vrf1601
for a detailed list of commands and sample
Bytes
Switched
572842
Bytes
Switched
--------
532978
Bytes
Switched
501241
51