Expansion Board Removal; Simm Removal - NEC POWERMATE V Service Manual

6-4 Minitower Repair

Expansion Board Removal

Remove the any installed expansion board(s) per the following steps.
1. Remove the system unit cover as previously described (see "System Unit Cover
Removal" in this section).
2. Label and remove any cables connected to the board.
Remove the screw that secures the board to the support bracket (see Figure 6-3)
3.
Figure 6-3 Removing the Screw in the Minitower
4. Pull the board out of the connector. Gently rock the board from side-to-side to
release it from its connector.
5. Replace the system unit cover.

SIMM Removal

Remove a SIMM from the system board as follows.
Remove the system unit cover as previously described (see "System Unit Cover
1.
Removal" in this section).
CAUTION: Reduce static discharge by touching
the system's metal chassis.