Desktop Repair; Disassembly And Reassembly; Powermate V Desktop Disassembly Sequence - NEC POWERMATE V Service Manual

Section 5

Desktop Repair

DISASSEMBLY AND REASSEMBLY

This section contains step-by-step disassembly procedures for the desktop systems. The
hard disk drive, and 3 1/2-inch diskette drive are installed and included in these disassembly
procedures. Reassembly is the reverse of disassembly. Each procedure is supported by a
simplified disassembly illustration to facilitate removal. The detailed exploded-view diagram
and parts lists for the desktop systems are shown later in this section.
A Phillips-head screwdriver is the only required tool. For complete disassembly of the
system unit, follow the disassembly order listed in Table 5-1. To reassemble, follow the
table in reverse order.
Individual removal procedures do not require the total disassembly of the computer. Each
of the following subsections lists the parts that must be removed before beginning the
removal procedure. To reassemble, follow the procedure in reverse order.
Table 5-1 PowerMate V Desktop Disassembly Sequence
Sequence Part
1 System unit cover
2 Expansion board(s)
3 PCI/ISA backboard
4 3 1/2-inch diskette and hard disk drives
5 Front panel assembly
6 Blank panel
7 Speaker assembly
8 SIMM memory
9 5 1/4-inch devices
10 Power supply
11 System board
See Page
5-2
5-3
5-5
5-5
5-7
5-8
5-8
5-9
5-10
5-11
5-13