NEC POWERMATE V Service Manual page 107

3. Remove the hard disk drive installed in the front slot as follows (see Figure 3-34):
T
Unplug the power and signal cables.
T
Remove the four drive screws (two on each side).
T
Remove the drive from the slot.
4. Remove the two screws that secure the drive bracket to the rear of the system
(see Figure 3-35).
Rear Slot
Drive Bracket
Figure 3-35 Removing the Drive Bracket Screws
5. Insert the first drive into the lower slot of the 3 1/2-inch drive bracket. Insert the
drive connectors so that the connectors face toward the center of the system unit.
6. Align the holes in the drive with the holes in the bracket.
7. Secure the drive to the bracket with the four screws, two to a side, that come with
the drive (see Figure 3-36).
Drive
Bracket
Figure 3-36 Securing the Drive to the Bracket
Option Installation
Screws
Drive
3-35