3.
Slide the speaker out from the tabs on the device cage (see Figure 5-10).
SIMM Removal
Remove SIMM sticks from the system board as follows.
1.
Remove the system unit cover, and any full size expansion boards as previously
described.
2.
Spread apart the two clips at each end of the SIMM stick (the clips are part of the
system board's connectors). Tilt the SIMM stick forward, allowing the post to
slide out of the hole in the SIMM stick.
Remove the SIMM stick from the system board. Repeat step 2 for each SIMM to
3.
be removed.
Speaker
Figure 5-10 Internal Speaker
NOTE: If more information is needed, see the
installation instructions in Section 3, Options.
Clips
Figure 5-11 SIMM Socket
Desktop Repair
5-9
Speaker Cable to
System Board