3.
Use the previously removed bracket screw to secure the bracket in place (see
Figure 3-33).
Screw
Tab
Figure 3-33 Securing the 3 1/2-Inch Drive Bracket
Replace the desktop front panel (see Replacing the Desktop Front Panel).
4.
Replace the system unit cover.
5.
Run the Setup program to set the new configuration.
6.
Minitower Storage Device Installation
The following subsections describe how to install 3 1/2-inch and 5 1/4-inch drives. The
installation procedures include:
T
installing a 3 1/2-inch drive in the minitower internal front slot
T
installing a 3 1/2-inch drive in the minitower rear slot
T
removing the minitower front panel
T
installing a minitower 5 1/4-inch device
T
replacing the minitower front panel.
NOTE: If a 1.2-MB diskette drive was installed,
remove the protective cardboard insert from the
drive.
Option Installation
Tabs
3 1/2-Inch
Drive Bracket
3-33