PCI/ISA Backboard Removal
Remove the PCI/ISA backboard per the following steps.
1.
Remove the system unit cover and any installed expansion slot boards as
previously described in this section.
2.
Remove the two screws that secure the backboard to the support bracket (see
Figure 6-20).
Pull the backboard out from its connector on the system board and remove it from
3.
the system.
System Board
Connector
System Board Removal
Remove the system board per the following steps.
1.
Remove the following components as previously described in this section:
T
system unit cover
T
expansion slot boards
T
PCI/ISA backboard
T
SIMMs
T
rear 3 1/2-inch internal drive
Screws
Figure 6-20 PCI/ISA Backboard
Minitower Repair
PCI/ISA
Backboard
Support Bracket
6-15