Installing The Desktop 5 1/4-Inch Device - NEC POWERMATE V Service Manual

Installing the Desktop 5 1/4-Inch Device

Install an accessible device into the desktop device cage as follows.
Remove the 3 1/2-inch drive bracket from the system unit (see Removing the
1.
Desktop 3 1/2-Inch Drive Bracket).
2. Remove the desktop front panel (see Removing the Desktop Front Panel).
3. Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
4. From the front of the system, insert the device, connector end first, into the device
slot.
Connect the device cables.
5.
Align the holes in the device with the holes in the cage.
6.
7. Secure the device to the cage with the four screws, two to a side, that come with
the device (see Figure 3-31).
NOTE: If the device comes with rails, do not
attach them. Remove any rails already attached.
NOTE: To easily access device connectors for
cabling, do not insert a 5 1/4-inch device all the
way into the slot.
Figure 3-31 Securing the Device
Option Installation
Two of Four
Screws
3-31