Save Changes; Bios Update Utility - NEC POWERMATE V Service Manual

Get Default Values
To load all the default Setup values in the Setup menus, select Load ROM Default Values
from the Main Menu. The program displays this message:
If, during bootup, the BIOS program detects a problem in the integrity of values stored in
NVRAM, it displays these messages:
The CMOS values have been corrupted or modified incorrectly, perhaps by an application
program that changes data stored in CMOS.
Press to resume the boot or
F1
into the menus. Other changes can be made before saving the values to NVRAM.
Load Previous Values
During a Setup session, if a mistake has been made and has not yet been saved to NVRAM,
the previously saved NVRAM values can be restored.
Selecting Load Previous Values on the Exit menu updates all the selections and displays this
message:

Save Changes

Save Changes saves all the selections without exiting Setup. Other menus selections can be
reviewed or changed.

BIOS UPDATE UTILITY

The system BIOS resides on a flash ROM in the system. The flash ROM can be updated,
should it ever become necessary. This feature allows the ROM BIOS chip to be flashed with
a new BIOS code through software, rather than replacing the chip.
Performing an update is done with a BIOS flash diskette. The diskette, which contains the
latest version of the BIOS code, can be obtained from NEC Technologies or, if a modem is
available, the latest BIOS can be downloaded from NEC's Bulletin Board Service (BBS).
NOTICE
Default values have been loaded!
[continue]
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
to run Setup with the ROM default values already loaded
F2
NOTICE
Previous values have been loaded!
[continue]
Setup and Operation 2-27