Simm Installation - NEC POWERMATE V Service Manual

3-16 Option Installation

SIMM Installation

Install a SIMM as follows.
Remove the system unit cover as previously described.
1.
2. Locate the SIMM sockets (see Figure 3-13).
Remove any currently installed SIMMs that are not needed.
Position the SIMM in the socket. The notched end of the SIMM allows only the
3.
correct positioning.
Insert the SIMM at an angle into the socket.
4.
5. Tilt the SIMM towards the locking tabs using equal pressure at the ends of the
SIMM until it locks into the socket (see Figure 3-15).
Clip
Replace any cables or boards that may have been removed.
6.
Replace the system unit cover.
7.
CAUTION: Before installing a SIMM, reduce
static discharge by touching the system's metal
chassis.
Figure 3-15 Inserting the SIMM
Notched End
of SIMM