NEC POWERMATE V Service Manual page 130

5-6 Desktop Repair
4. Remove the four 3 1/2-inch drive bracket screws (see Figure 5-6).
Screw
Tab
Remove the four 3 1/2-inch diskette drive screws; two on each side of the drive
5.
bracket (see Figure 5-7).
Remove the two 3 1/2-inch hard disk drive screws; two on each side of the drive
bracket (see Figure 5-7).
Pull the drives out from the front of the bracket.
6.
Diskette Drive
Screws
Hard Disk
Drive Screws
Figure 5-7 3 1/2-Inch Diskette and Hard Disk Drive Screws
NOTE: When reinstalling the drives, note that
all power cables are keyed to fit only in the
correct position. The red edge of the diskette
drive signal cable is positioned as shown.
Figure 5-6 3 1/2-Inch Drive Bracket
Diskette Drive
Power
Supply
Tabs
3 1/2-Inch
Drive Bracket
Hard Disk Drive
Diskette Drive
Screws
Hard Disk
Drive Screws