Assembling The Microphone Holder - NEC POWERMATE V Service Manual

2-8 Setup and Operation
4. If installing a multimedia system, connect the speakers as follows.
T
Locate the right speaker (has the controls on the front) and the speaker cable
attached to the back.
T
Locate the left speaker and the speaker cable attached to the back.
T
Connect the right speaker cable to the left speaker cable.
T
Connect the speaker input cable to the right speaker and to the line out jack
on the back of the system.
T
Connect the AC adapter to the right speaker and to a surge protector or wall
outlet.
T
Press the power switch. The power lamp lights.
T
Adjust the volume control as required.
5. Assemble and connect the microphone (multimedia systems only) as follows.
T
Slide the microphone holder into the slot in the microphone stand as far as it
will go (see Figure 2-10).
T
Slide the microphone cable and microphone into the holder. Adjust the
microphone by pivoting it up and down and side to side.
Microphone
Cable
Figure 2-10 Assembling the Microphone Holder
Microphone
Holder
Microphone
Microphone
Stand