Desktop Network Board Connections - NEC POWERMATE V Service Manual

3. If setting up a network-ready system, connect the appropriate network cable to
the network board at the rear of the system (see Figure 2-3).
CAUTION: If adding a T-connector, be sure
that other network users are logged off the
system before connecting the cable.
Figure 2-3 Desktop Network Board Connections
If installing a multimedia system, connect the speakers as follows.
4.
T
Locate the right speaker (has the controls on the front) and the speaker cable
attached to the back.
T
Locate the left speaker and the speaker cable attached to the back.
T
Connect the right speaker cable to the left speaker cable.
T
Connect the speaker input cable to the right speaker and to the line out jack
on the back of the system.
T
Connect the AC adapter to the right speaker and to a surge protector or wall
outlet.
T
Press the power switch. The power lamp lights.
T
Adjust the volume control as required.
AUI Thick Ethernet Connector
BNC Thin Ethernet Connector
Setup and Operation
RJ-45
Connector
2-3