Installing The Minitower 5 1/4-Inch Device - NEC POWERMATE V Service Manual

3-38 Option Installation

Installing the Minitower 5 1/4-Inch Device

Install an accessible device into the minitower device cage as follows.
Remove the minitower front panel as previously described.
1.
2. Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
If installing the device into the top 5 1/4-inch slot, go to Step 4. Otherwise, locate
3.
the device rails that ship with the system. Attach the rails to the sides of the device
with the four screws that come with the device (see Figure 3-40).
If installing an accessible device (diskette drive, tape drive, CD-ROM reader),
attach the rails to the device so that the front of the device extends beyond the
chassis and is even with the blank panels on the front of the system.
NOTE: If the 5 1/4-inch device comes with
drive rails, do not attach them. Remove any rails
already attached. See the documentation that
comes with the device.
If installing the device into the top 5 1/4-inch
slot, do not attach the device rails that came with
the system.
The rails must be used when installing a device in
the middle and bottom 5 1/4-inch device slots.
Figure 3-40 Attaching the Device Rails
Device
Device Rails