Replacing The Front Panel - NEC POWERMATE VE - SERVICE MANUAL 08-1996 Service Manual

3-26 Option Installation
7. Secure the device to the cage with the four screws, two to a side, that come with
the device (see Figure 3-24).
8. Replace the drive bracket (see "Replacing the 3 1/2-Inch Drive Bracket").

Replacing the Front Panel

Replace the front panel as follows.
1. Align the four front panel tabs with the holes in the front of the system unit.
2. Evenly press the front panel into position until the tabs lock the panel in place (see
Figure 3-25).
Figure 3-24 Securing the Device
Two of Four
Screws