Unattended Start; Security Hot Key (Ctrl-Alt-); Exit Screen; Exit Saving Changes - NEC POWERMATE PRO150 Manual

Unattended Start

Controls when the security password is requested. The options are Enabled
and Disabled. The default is Disabled. The User password must be enabled
before you can enable this option. If Enabled is selected, the system boots,
but the keyboard will be locked until the User password is entered.

Security Hot Key (CTRL-ALT-)

Sets a hot key that, when pressed, locks the keyboard until the User
password is entered. The Keyboard LEDs flash to indicate that the
keyboard is locked. When you enter the User password, you do not have to
press the <Enter> key.

Exit Screen

This section describes the different ways to exit and save or not save
changes made in the Setup program.

Exit Saving Changes

Saves the changes to CMOS RAM and exits the Setup program. You can
also press the <F10> key anywhere in the Setup program to do this.

Exit Discarding Changes

Exits the Setup program without saving any changes. This means that any
changes made while in the Setup program are discarded and NOT SAVED.
Pressing the <Esc> key in any of the four main screens will do this.

Load Setup Defaults

Resets all of the setup options to their defaults. You can also press the <F5>
key anywhere in the Setup program to do this.
This selection loads the default Setup values from the ROM table.

Discard Changes

Discards any changes you made during the current Setup session without
exiting the program. This selection loads the CMOS RAM values that were
present when the system was turned on. You can also press the <F6> key
anywhere in the Setup program to do this.
3-18
Using the Setup Program