Isa Lfb Size; Isa Lfb Base Address; Video Palette Snoop; Latency Timer (Pci Clocks) - NEC POWERMATE PRO150 Manual

ISA LFB Size

Sets the size of the linear frame buffer. The options are Disabled, 1 MB,
2 MB, and 4 MB. The default is Disabled. If this is set to anything other
than Disabled, the ISA LFB Base Address field will appear.

ISA LFB Base Address

Reports the base address of the LFB. There are no options. This field will
not appear if the ISA LFB Size is set to Disabled.

Video Palette Snoop

Controls the ability of a primary PCI graphics controller to share a common
palette with an ISA add-in video card. The options are Enabled and
Disabled. The default is Disabled.

Latency Timer (PCI Clocks)

Sets the length of time an agent on the PCI bus can hold the bus when
another agent has requested the bus. Valid numbers are between 0 and 256.
The default is 66.

ECC Support

Reports the presence or absence of ECC support. If parity SIMMs are
installed on the system board, the field reports Detected and ECC is
enabled. If non-parity SIMMs are installed, the fields reports Not Detected
and ECC is not enabled. This field is information only; there are no options.

Plug and Play Configuration Subscreen

This section describes the options found on the Plug and Play configuration
subscreen.

Configuration Mode

Sets how the BIOS gets information about ISA cards that do not have Plug
and Play capabilities. The options are Use Setup Utility and Use ICU (ISA
Configuration Utility). The default is Use Setup Utility.
PowerMate Pro150 System
3-13