Checking The Power Cord; Connecting Devices When Configuring The System; Before Installing Optional Items - NEC POWERMATE PRO150 Manual

Checking the Power Cord

!
WARNING
Do not attempt to modify or use the supplied AC power
cord if it is not the exact type required.
In some cases, the power cord supplied with this system might not be
compatible with the AC wall outlet in your region. If this is true, you must
obtain a suitable power cord that meets the following criteria:
The cord must be rated for use at the AC voltage available, with a
current rating that is at least 125% of the current rating of the product.
The AC plug end must be terminated in a grounding-type male plug
designed for use in your region. The cord must be labeled or marked to
indicate it has been certified by an agency acceptable in your region.
The connector at the product end must be an IEC 320, sheets C13-14,
female connector (or the equivalent EN 60 320 connector).
The cord must be less than 14.8 feet (4.5 meters) long and be created
with <HAR> (harmonized) or VDE certified cordage.

Connecting Devices When Configuring the System

To configure the system, you must add a monitor and keyboard to the
system. If the system normally operates without a monitor or keyboard (for
example, as a network server), you may remove these devices after running
Setup (described in Chapter 3).

Before Installing Optional Items

Before installing other option, such as optional boards and software,
connect the keyboard and monitor and let the power-on self test (POST)
run. Then, when first start-up is successful, add your drives, boards,
system board components, and software.
Chapter 3 describes how to run the Setup program. Run Setup at first
start-up and at any time when you change the configuration by adding
or removing optional parts.
Chapter 4 describes how to take apart and reassemble the system.
Chapter 5 describes how to install and configure system board options.
If the POST is not successful, see "Turning on the System at First Startup" in
this chapter and "Problems at Initial System Start-up" in Chapter 6.
2-4
Installing Your System