Table of Contents
Advertisement
Removing an Additional 3 1/2-Inch Device — Desktop
The desktop system has an additional 3 1/2-inch bay that can accommodate a
second hard drive, or a second diskette drive.
(For instructions on removing the internal hard drive, see "Removing a 3 1/2-
Inch Internal Hard Drive — Desktop").
To remove a 3 1/2-inch device from the additional 3 1/2-inch accessible device
bay, proceed as follows.
1. Remove the system unit cover (see "Removing the Small Desktop or
Desktop Cover").
2. Remove the front panel (see "Removing the Front Panel — Desktop").
3. Label and disconnect the device cables.
4. Remove the two screws securing the drive in the bracket (see the following
figure).
Locating 3 1/2-Inch Accessible Device Screws — Desktop
5. Pull the device out of the device bay.
6. If you are installing a new device, see "Installing an Additional 3 1/2-Inch
Device — Desktop."
If no new device is going in the bay, place the blank plastic panel into the
opening on the front panel and then replace the front panel. See the figure in
"installing an Additional 3 1/2-Inch Device — Desktop."
Installing an Additional 3 1/2-Inch Device — Desktop
The desktop system has an accessible 3 1/2-inch bay that can accommodate a
second hard drive, or a second diskette drive.
(For instructions on replacing the internal hard drive, see "Installing a 3 1/2-Inch
Internal Hard Drive — Desktop").
Disassembly and Reassembly 3-33
Advertisement
Table of Contents
