Desktop 5 1/4-Inch Device Installation; Desktop 3 1/2-Inch Drive Bracket Removal - NEC POWERMATE P60D Service Manual

3-24 Options

DESKTOP 5 1/4-INCH DEVICE INSTALLATION

To install a 5 1/4-inch device into the desktop system, the top cover, 5 1/4-inch blank panel,
and the 3 1/2-inch drive bracket must first be removed. "Minitower 5 1/4-inch Device In-
stallation" instructions are provided later in this section. When device option kits come with
rails preattached. The drive rails must be removed and the screws are reused to secure the
drives to the drive bracket.

Desktop 3 1/2-inch Drive Bracket Removal

Remove the 3 1/2-inch drive bracket from the desktop system unit as follows.
1. Remove the top cover as previously described.
Remove the four 3 1/2-inch drive bracket screws (see Figure Section 3-22).
2.
Without removing the power and signal cables, place the 3 1/2-inch bracket with
3.
the diskette drive and hard disk drive attached on the power supply.
Figure Section 3-22 3 1/2-Inch Drive Bracket Screws
NOTE: Do not remove the 5 1/4-inch blank
panel when installing a hard disk drive.
The 3 1/2-inch hard disk drives must be mounted
in 5 1/4-inch bracket.
3 1/2-Inch
Drive Bracket
Power Supply
Four Screws